Al Fakher Hypermax Prime 50K Prefilled Pod Kit

The Al Fakher Hypermax Prime 50K is a rechargeable prefilled pod kit from the Crown Bar range. The 1000mAh battery stays with you, and when the e-liquid runs out you simply snap in a fresh Snap Dual pod module and two new 10ml prefilled containers instead of binning the whole device.

Every container is sealed with UK TPD compliant nicotine salt e-liquid, ready to use straight from the box. This is a prefilled device, not one you top up yourself, and the coil sits inside the pod module rather than the battery, which is what keeps flavour and puff count consistent from the first pull to the last.

Al Fakher Hypermax Prime 50K specifications

Key features at a glance

• Up to 50,000 puffs. Each pod module and its two 10ml prefilled containers are rated for this figure under lab testing, giving you a long session before a refill pack is needed.
• 1000mAh rechargeable battery. Charges over USB-C with Quick Charge 2.0, so you spend less time waiting and more time vaping.
• Snap Dual pod module. The coil sits inside the module rather than the battery, so every refill pack gives you a fresh coil, not just fresh liquid.
• Unlimited refill pack swaps. The battery stays with you for the life of the device. Only the module and containers get replaced when they run dry.
• Adjustable airflow. Tighten it for a mouth to lung draw or open it up for a looser restricted direct lung inhale.
• Draw activated firing. No buttons, no menus, no settings. Just inhale and it fires.
• Mesh coil with Big Cloud v2.0. Heats more evenly than older round wire coils, which brings out clearer flavour and denser vapour.
• Flow Sense smart e-liquid control. Feeds liquid to the coil at a steady rate, keeping the wick saturated without flooding or dry hits.
• Silk Glow battery display. Lights up on every inhale so you always know your remaining charge at a glance.
• UK TPD compliant nicotine salt. Sealed in every container, up to the legal UK limit of 20mg/ml.
• 10 starter kit flavours. With the full range of 45 flavours available separately as Prefilled pods.

How the Snap Dual pod system works

Older Al Fakher kits, including the Al Fakher 30K, keep the coil inside the battery. That means the refill containers only ever hold liquid, and the coil itself starts to fade in flavour quality after the first fill.

The Hypermax Prime 50K changes that by moving the coil into the pod module. When a set of 10ml containers runs dry, you snap in a completely fresh pod module and two new containers from your next refill pack, all onto the same 1000mAh battery. That gives you a new coil, new e-liquid, and a new module every single time, rather than one ageing coil trying to push through pack after pack of liquid.

There is no limit on how many refill packs you can run through one battery. Buy a pack, snap it in, vape it down, replace it, and repeat. The battery is the only part designed to last the lifetime of the device, which keeps the cost per puff low compared with a fully single-use disposable.

The 50,000 puff figure is Al Fakher's tested maximum using short, tight draws under lab conditions. Longer inhales, open airflow, and frequent chain vaping will use e-liquid faster, so actual puff counts vary from person to person.

Battery, coil and airflow

The 1000mAh battery charges over USB-C with Quick Charge 2.0, so it tops up quickly rather than needing an overnight charge. The Silk Glow display lights up on every inhale, giving you a quick read on remaining charge. There are no buttons or settings, the kit is fully draw activated and fires as soon as you inhale.

Each pod module runs a mesh coil with Big Cloud v2.0 technology, which heats more evenly than older round wire coils for clearer flavour and denser vapour. Behind it, Flow Sense keeps the wick steadily saturated so you get consistent flavour without flooding or dry hits. Airflow is adjustable, so you can tighten it for MTL or open it up for RDL.

Who the Hypermax Prime 50K is for

This kit suits vapers who want a long-lasting device with a fresh coil on every refill, not just fresh liquid. It also works well if you are moving on from single-use disposables, since the draw activated firing and tool free pod swap feel familiar, while the rechargeable battery keeps running costs down.

How to set up your Al Fakher 50K

• Take the pod module and the two 10ml prefilled containers out of the box.
• Pull the small plastic plug from the bottom of each container.
• Snap both containers into the Snap Dual pod module until they click.
• Remove the plastic clip from the side of the assembled module.
• Slot the module onto the 1000mAh battery body until it locks in place.
• Press the mouthpiece down once to engage the system.
• Wait two to three minutes for the mesh coil to fully saturate, then inhale to vape.

Once a set of containers runs dry, pick up a fresh Al Fakher Prime 50000 refill pack. Each pack includes a new pod module and two new prefilled containers, so you repeat the same steps on the same battery. New coil, new e-liquid, new module, same battery.

What's in the box

• 1 x Al Fakher Hypermax Prime 50K battery (1000mAh, rechargeable)
• 1 x Snap Dual pod module with mesh coil housed inside
• 2 x 10ml prefilled containers in your chosen flavour
  

Price

Al Fakher 50K flavours

Ten flavours ship in the Hypermax Prime starter kit. Once those run out, all 45 flavours across the full Al Fakher 50K refill pod range fit straight into the same Snap Dual module.

All 45 flavours across the Al Fakher 50K refill pod range are available separately on the Al Fakher collection page.